All-In-One Commode, Safety Summary

All-In-One Commode

Assembly, Installation and Operating Instructions

Model No. 9630E

SAFETY SUMMARY

Thefollowingrecommendationsaremadeforthesafe installation of the Commodes:

WARNING

DO NOT install this equipment without first reading and understanding this in- struction sheet. If you are unable to un- derstand these instructions, contact a healthcare professional, dealer or tech- nical personnel if applicable before at- tempting to install this equipment - oth- erwise, injury or damage may occur.

Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact Dealer/Carrier for further instruction.

Snap buttons MUST be fully engaged and aligned in the proper height adjustment hole of each leg before use. This ensures that the legs are securely locked and an even height adjustment is achieved.

Make certain ALL screws, nuts and/or bolts are tight at all times.

Inspect rubber tips on the leg exten- sions for rips, wear or if they are miss- ing. Replace them immediately if any of these conditions exist.

Leg extensions with rubber tips MUST be in contact with the floor at all times.

Users with limited physical capabilities should be supervised or assisted when using the commode.

The Commode Model No. 9630E has a weight limitation of 135 kg.

LEG HEIGHT ADJUSTMENT (FIGURE 1)

1.Selectthedesiredheightforthecommodebyalign- ing the snap button of each leg extension with the appropriate adjustment hole in the leg frame.

2.Make certain that the snap buttons are fully en- gaged into the adjustment hole of each leg frame and are at the same height before using.

Snap Button

FIGURE 1 - LEG HEIGHT ADJUST-

MENT

INSTALLING AND REMOVING THE COMMODE SEAT AND LID (FIGURE 2)

CAUTION

Before removing/installingseat and lid, al- low seat/ring to reach room temperature if exposed to cold. This will help prevent the seat clamps from breaking when being re- moved/installed onto commode back frame rail.

1.Align the seat clamps of the toilet seat onto the back frame rail. (Each clamp should sit out- side the pail holders). Push down on seat until it clamps firmly into place.

2.Repeat the same process for the lid.

3.When removing the seat or lid, remove the lid first and then the seat. To remove, grasp the back corner of the lid and/or seat and lift up firmly.

CARE: Use a damp cloth and soap to clean.

NOTE: To make raising or lowering the seat/lid easier, you may lubricate the commode back frame rail with a very small amount of petroleum jelly or furniture polish.

WARNING

Toilet seat MUST be DOWN before sitting on the commode. Pail holders are NOT constructed to support the weight of an individual, ONLY the pail and its contents.