4.Connect other end of air hoses to the pump.
5.Connect air hoses with fittings to the air chamber openings on the pad (FIGURE 2).
6.Install sheet over pad and bed mattress.
7.Refer to USING/ADJUSTING THE PUMP in this instruction sheet.
Air Chamber Openings
Pad
3.Turn knob on pump to the maximum setting (clock- wise).
NOTE: It will take approximately 15 minutes for the pad to be fully inflated at the maximum p.s.i.
NOTE: Keep hose attached to the pad and the pump, otherwise, deflation will occur.
4.Refer to ADJUSTING THE PUMP in this instruc- tion sheet.
Hose
FIGURE2-INSTALLINGTHECAREGUARDAPP- ATTACHINGHOSETOPAD
USING/ADJUSTING THE PUMP (FIGURE 3)
WARNING
DONOT,underanycircumstances,cutorremove the round grounding prong from any plug used with or for Invacare products. Some devices are equipped with
Adjusting
NOTE: The pressure of the pump can be adjusted to provide maximum effectiveness and pressure relief for the patient.
NOTE: The pressure can be adjusted with a range from 1 to 8, with 1 being the lowest pressure settting.
NOTE: The pump will cycle every five(5) minutes inflating and deflating the two air chambers.
1.Put patient on the pad.
2.Set the pressure to desired setting.
3.Slide the flat portion of your hand between the pad and the matress of the bed.
NOTE: There should be a cushion of air between the pad and the mattress of the bed. If not, check pump and pad for leaks, tears, kinks, or breaks. If damage is found, DO NOT use. Contact Carrier/Dealer for further instructions.
4.If pressure is unacceptable for patient, repeat STEP 2 until desired pressure is reached.
Pump
Power
Switch
Knob
Using
1.Plug power cord into outlet.
2.Turn power switch to the ON position.
NOTE: The green light will be illuminated when the pump is in the ON position.
FIGURE 3-USING/ADJUSTING THEPUMP
CARE AND MAINTENANCE
1.The pad can be cleaned by wiping it with a germicidal disinfectant solution.
2