HomeFill™Ready Rack for Perfecto2™2Part No 1148363
Installing the HomeFill Ready RackNOTE: For this procedure, refer to FIGURE 1 on page 3.
1. Position the Invacare Perfecto2 concentrator in the desired location.
2. Align the HomeFill ready rack above and toward the rear of the concentrator (Detail
“A”).
3. Move the ready rack forward until the rear pins fully engage the concentrator
mounting holes (Detail “B”).
4. Rotate the latch down over the handle to secure in place (Detail “B”).
5. Orient and place the HomeFill compressor onto the installed ready rack as shown
(Detail “C”).
NOTE: The HomeFill compressor will prevent the latch from becoming unsecured.
6. Connect the HomeFill fill hose to the concentrator and compressor. Refer to Perfecto2
owner’s manual, part number 1143482, for proper connections.
Transporting WARNING
DO NOT move the concentrator while the HomeFill compressor is on the ready
rack. Separate the HomeFill compressor from the ready rack prior to transporting.
1. Disconnect the HomeFill unit from the concentrator and remove unit from the ready
rack prior to transporting.
NOTE: For operating instructions of the concentrator and/or HomeFill compressor, refer to
Perfecto2 owner’s manual, part number 1143482, or HomeFill owner’s manual, part number
1100873.