Invacare Quick Release Caster

2. Depress the detent pin of the quick release caster

head tube cap and install over the top of the quick

release caster fork stem.

3. Release the detent pin of the quick release caster

head tube cap and pull on the caster fork to make

sure the fork is securely attached to the chair.

4. Reinstall and securely tighten the bolt and locknut

that secure the two (2) spacers and caster onto the

quick release caster fork.

5. Repeat this procedure for the opposite side.

WARNING

There are several configurations of the quick

release caster. If caster fork stem DOES NOT

look like the drawing in FIGURE 2 when in-

stalled, DO NOT USE. Contact Customer Ser-

vice, 1-(800)-333-6900.

NOTE: When removing the quick release casters for

any reason, reinstall the quick release caster head

tube cap onto the fork stem so it can be located eas-

ily for future use.

Caster Fork

Stem

Approximately

1/4-inch

Caster

Head

Tube

Caster Head

Tube Cap

Detent Pin

Caster Head

Tube

Bolt

NOTE: Frame Shown

For Reference Only

FIGURE 2 - INSTFIGURE 2 - INST

FIGURE 2 - INSTALLING ALLING

ALLING ALLING

ALLING THE QUICK-RELEASETHE QUICK-RELEASE

THE QUICK-RELEASETHE QUICK-RELEASE

THE QUICK-RELEASE

CASTERASTER

ASTERASTER

ASTER

Invacare Corporation www.invacare.com

One Invacare Way

Elyria, Ohio USA

44036-2125

800-333-6900

Technical Support

800-832-4707

Invacare is a registered trademark of Invacare Corporation

Form No. 94-150 P/N 1050205 Rev. A (1) - 11/99