Invacare 1487, T1496 operating instructions I.V./O2 Cylinder Holder Accessory Kit, Safety Summary

I.V./O2 Cylinder Holder Accessory Kit

Assembly, Installation and Operating Instructions

Model Nos. 1487,1496 and T1496

NOTE: Check all parts for shipping damage. If ship- ping damage is noted, DO NOT use. Contact Dealer/ Invacare for further instructions.

SAFETY SUMMARY

The following recommendations are made for the safe installation of the IV/O2 Cylinder Holder Accessory Kit:

WARNING

DO NOT assemble or use this equipment without first reading and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions or In- structions, contact a healthcare profes- sional, dealer or technical personnel if ap- plicable before attempting to install this equipment - otherwise, injury or damage may occur.

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely.

Follow the Oxygen Cylinder manufactur- ers guidelines for proper usage of the oxy- gen cylinder.

INSTALLING IV/O2 CYLINDER HOLDER (FIGURE 1)

NOTE: IF rear step tube is 7/8-inch diameter tubing, in- stall the long tube guide insert into the rear step tube be- fore installing the IV/O2 cylinder holder.

1.Place the IV/O2 cylinder holder and slide it onto the rear step tube of the wheelchair.

NOTE: IF rear upright tubing is 7/8-inch diameter tub- ing, install the short tube guide insert over the rear upright before installing and securing the IV/O2 cylin- der holder bracket.

2.Push the bracket of the IV/O2 cylinder holder over the rear upright of the wheelchair and secure in place with the hex screw, spacer and locknut.

3.Secure IV/O2 cylinder holder to push handle using a ty-wrap.

4.Loosen the short adjustment knob to move IV/O2 cylinder holder to desired height and then retighten.

5.Use the long adjustment knob on the IV/O2 cylinder holder bracket to secure the oxygen cylinder in place.

IV/O2 Cylinder Holder

Ty-wrap
Push		Short
Handle
		Adjustment
Short
		Knob
Tube
Guide
Insert
Rear	Spacer	Long
Upright
		Adjustment
Rear Step		Knob
Tube
Long Tube Guide	Hex	Locknut
Insert	Screw Bracket

FIGURE 1 - INSTALLING IV/O2 CYLINDER

HOLDER

Invacare Corporation	www.invacare.com
USA	Canada	Invacare® andYes,you can.are trademarks of Invacare
One InvacareWay	5970 ChedworthWay
Elyria, Ohio USA	Mississauga, Ontario	Corporation.
44036-2125	L5R 3T9, Canada	© 2000 Invacare Corporation
800-333-6900	905-890-8838	Form No. 91-201 Part No. 1027931 Rev E (1) 12/00