Quick Start Guide for
Step 1.
Unlock the leg locks #10 (shown by arrows at left).
Extend tripod legs.
Lock the leg locks afterwards.
| Step 2. |
| Turn the center tripod lock knob (#9) to secure and stabilize the tripod. |
| Tighten to a firm feel. |
| Caution: Make sure you loosen the tripod lock knob before |
| collapsing the tripod to store away. |
|
|
Threaded | Step 3. |
Attach mount to tripod by placing the mount onto the threaded bolt on | |
bolt | tripod. Then turn the mount until it is securely fastened to the tripod. |
| Use height adjustment handle (#8) to adjust the height of the mount. |
#12 knob | (Caution: Do not extend beyond 6 inches from top of tripod.) |
| |
| Make sure to tighten the tripod height lock knob (#12). |
| #8 |
|
|
| Step 4. |
| Lift the battery cover. Carefully pull out the battery holder from the |
| compartment. Be sure not to accidentally disconnect the wires. |
| Step 4a. |
| Insert 8 AA batteries (not included) in the holder. Refer to the diagram |
| on the holder to orient the batteries properly. Replace the holder back |
| into the battery compartment and replace the lid. |
| For reference: the battery pack fits in with wires on the bottom right. |
| (See arrow in photo). Use only fresh batteries. Using old or low batteries |
| may cause error messages. |
| An optional AC adapter and 12V car plug cable are also available |
| for purchase at www.iOptron.com. |
|
|
| Step 5. |
#2 knob | Attach telescope to mount using dovetail lock knob (#2). |
|
iOptron Corp. 6F Gill Street Woburn, MA 01801 USA (781)
