1. Introduction
Thank You for purchasing the iSimple ISBT21
2. Compatibility
To ensure proper operation please verify that your GateWay (uPAC) is updated with the latest firmware. Please visit www.isimplesolutions.com for firmware updates and compatibility information.
3. Installation
The GateWay (uPAC) must be disconnected from the vehicle and allowed to sit for no less than five minutes before installing the ISBT21. The vehicle wiring harness may be left in place, but MUST BE DISCONNECTED from the GateWay (uPAC) interface before installing the Bluetooth Module. After you have disconnected the GateWay (uPAC) and waited at least five minutes, connect the
When securing the ISBT21 into the dash of the vehicle, placement of the interface is very important. Bluetooth technology supports devices communicating wirelessly up to 20 feet away in most cases. However metal structures inside the dash can reduce the communication between the module and the Bluetooth device. Please keep this in mind when installing the ISBT21 module and ensure to place it where it will have the least obstructions from metal objects.
With all wiring connected, reconnect the GateWay (uPAC) to the vehicle harness.
After all connections have been made, turn the ignition on in the vehicle. Wait 1 minute for the device to initialize. Cycle ignition OFF, and ON again. Enter Satellite radio mode to access the GateWay (uPAC) and use the Bluetooth Module.
4