Installation Instructions
7212
3/4” Offset Jamb Mounted Bottom Pivot
|
| Right hand |
Door | installation shown; | |
leaf | left hand opposite | |
Bearing |
| Right hand |
| installation | |
spindle |
| |
|
| |
Jamb | 3/32” Allen | Left hand |
leaf | wrench | installation |
Set |
| Figure 1 |
screw |
|
1.Prepare and mortise bottom of door and side jamb to receive pivot set. Determine pivot location using dimensions on reverse side. Be sure to properly locate and mark center point of the jamb leaf spindle. Care must be taken to ensure that jamb leaf is completely level. Place level against jamb leaf surfaces as shown in Figure 1. The bottom pivot set is handed. Hand of pivot must match hand of door.To determine hand of door, see diagrams above.
2.Locate, drill, and tap
3.At this point, the top pivot of the set should be installed. After top pivot installation, hang door. Refer to instruction sheet packed with top pivot for details.
4.If height adjustment is necessary for proper door clearance, adjust bottom pivot as follows:
A.Remove top pivot pin and take door down.
B.Use 3/32” Allen wrench provided to loosen set screw in jamb leaf (see diagam above).
C.Adjust bearing spindle height with 5/8” Allen wrench. Range is plus 1/8”, minus 1/16”.
D.
!CAUTION
Improper pivot set installation can lead to personal injury or property damage. Follow all instructions carefully. For questions contact Technical Support at
16000 Rev. 4 | © 2006 |