Installation Instructions
7230F
3/4” Heavy Duty Offset Bottom Pivot
Cap screw
Right hand
installation shown; left hand opposite
Pivot cap
Door leaf
3/32” set screw
Right hand | Pivot shaft | Left hand | Figure 1 |
installation | installation |
Base plate
1.Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location using dimensions on reverse side. Be sure to properly locate and mark pivot center point of the base plate. The bottom pivot set is
2.Prepare bottom of door: Locate, drill, and tap
3.At this point, hang door. Refer to instruction sheet packed with top pivot for details.
4.If height adjustment is necessary for proper door clearance, adjust bottom pivot as follows:
A.Loosen set screw using 3/32” Allen wrench provided (see diagram above).
B.Use 5/16” Allen wrench to adjust pivot shaft height as needed (Figure 1).
C.Tighten set screw firmly.
5.Fasten pivot cap as shown. Secure with cap screw.
!CAUTION
Improper pivot set installation can lead to personal injury or property damage. Follow all instructions carefully. For questions contact Technical Support at
26362 Rev. 3 | © 2006 |