Jacuzzi BM43000 Tools And Materials, Read And Follow All Instructions, Before You Begin, Level

BEFORE YOU BEGIN

READ AND FOLLOW ALL INSTRUCTIONS

!Observe all local plumbing and building codes.

!Carefully inspect the new lavatory for damage.

!If the existing lavatory does not have supply shut-off valves, you will install them before installing the new lavatory.

!Rough-in information is included with your lavatory. The rough-in information shown will be helpful in placing the lavatory, water supply piping, shut-off valves and drain in their proper positions.

CAUTION: Your new lavatory is finished to an attractive high gloss. It may also be heavy and difficult to lift. To protect the finish and avoid possible damage before and after installation, please handle your lavatory with care. Place the lavatory on a thick bed of newspapers when working on it before installation.

TOOLS AND MATERIALS

You can determine which tools and materials are necessary by reading the complete installation instructions and examining the job you have to do.

These are normally needed:
utility knife	basin or pail and sponge
flat blade screwdriver	hammer and nails
drill	chisel
saber saw or keyhole saw	square
emery cloth	cardboard, newspapers or a dropcloth

Level

	Hacksaw
	Basin Wrench
Pipe Wrench	Tubing Cutter
(12")
	Safety Glasses
Adjustable Wrench	Tape Measure
(10")

The following materials are optional, in case existing materials are unusable: Two (2) shut-off valves with 1/2" I.P.S. outlet, (check house piping to determine valve inlet dimension.),

1/2" I.P.S. hot and cold water supply tubes with compression nut and ferrule, drain tail pipe (two for double bowl sinks) and trap,

additional drain pipe as required, 2" x 4" board

2