![](/images/new-backgrounds/1004238/42387x1.webp)
WATER CONNECTION
1.Before connecting the water supply, flush the line into a bucket to remove any debris.
2.Place the coupling nut, friction washer and universal washer onto the plain end of supply tube as shown.
NOTE: The same universal washer will be used to make the flanged
3. Temporarily make connection to tank supply shank,
4.Remove supply tube and cut to length including the extra 1/4". Remove any burrs from inside the cut end. Slip compression nut and ring (ferrule) onto the
5. Connect supply tube to supply shank once more and
supply to allow the extra 1/4" to be inserted into
UNIVERSAL
WASHER
FRICTION
WASHER
COUPLING
NUT
COMPRESSION NUT
FERRULE
6.Tighten both the coupling nut at the tank and the compression nut at the
7.Turn on water supply and
Adjustment (A)
1. WATER LEVEL IN TANK
Turn the water level adjustment screw clockwise to lower or
2.TANK REFILL
Turn Flow Control screw clockwise to slow or
NOTE: If either screw is turned clockwise too far, the float valve may not activate.
3. FLAPPER ADJUSTMENT
WATER LEVEL ADJUSTMENT SCREW
FLOW CONTROL SCREW
REFILL
TUBE
The length of the chain that connects the lever arm to the flapper may need to be adjusted. (Move the hook to another link)
A)TOO MUCH SLACK may not permit the flapper to lift far enough to properly activate the flush valve.
B)NOT ENOUGH SLACK in the chain may keep the flapper from closing properly.
3.REFILL TUBE
Make sure the refill tube is properly inserted in the top of the flush valve.
4