3
Antenna placement with mounting base: ! Before the following step, please make sure that you have enough protection when you try to drill on
wall to install the antenna.
! Please check the signal reception and make sure you can get a good signal at the location where you are going to install the antenna.
1. Indoor wooden wall mounting installation:
Step 1: Mark the fixing position with a pencil or
pen (Please use the mounting base to
mark the position).
Step 2: Take out the attached screws, using
screw driver to fix these screws
through the mounting base and fix it
on the wall.
Step 3: Attach the antenna to the mount base,
and check the signal reception.
2. Indoor concrete or RC wall mounting
installation:
Please note, when you use the electric drill, you should wear the eyes protection goggles,
and the drill bit must be fixed, to avoid any injury.
Step 1: Take a electric drill, use a drill bit
to drill a 35mm deep hole. Then
clean the hole.
Step 2: Take out the plastic pole, using
hammer to ham it into the hole
that made at step1.
Step 3: Take out the screws, use screw
driver, screw them through the
mounting base onto the plastic
pole.
Step 4: Attach the antenna to the mount
base, and check the signal
reception.
3. Indoor wall mounting installation with the Velcro:
Please note, clean the surface before stick the Velcro.
Step 1: Use the Velcro inside the box, and stick to the mounting base.
Step 2: Make sure the antenna can get a good signal reception at the location and position you are
going to attach.
Step 3: Stick the mounting base with the Velcro, and make the mounting base is secure.
Step 4: Attach the antenna to the
mount base, and check
the signal reception.