CONTROLS (CONT.)
Alarm Setting†
1.Press Menu/Up Level at any screen to display Top Menu (may require repeated presses, depending on which menu state the unit was previously in).
2.Use Up/Down arrows to highlight Alarm. Press Enter to confirm; or press Alarm to go directly to the Alarm menu.
3.Use Up/Down arrows to select an Alarm slot to edit. Press Enter to confirm. Hour field becomes highlighted.
4.Use Up/Down arrows to set Hour. Press Enter to confirm. Minute field becomes highlighted.
5.Use Up/Down arrows to set Minutes. Press Enter to confirm. AM/PM field becomes highlighted.
6.Use Up/Down arrows to set AM/PM. Press Enter to confirm.
7.Use Up/Down arrows to set Day of Week, Weekdays, Weekends, Everyday or
8.Use Up/Down arrows to set Alarm source. Press Enter to confirm. Alarm is set!
Note: During
†Use this same procedure to modify a previously set Alarm.
To Enable/Disable a Set Alarm
1.Press Menu/Up Level at any screen to display the Top Menu (may require repeated presses, depending on which menu state the unit was previously in).
2.Use Up/Down arrows to highlight Alarm. Press Enter to confirm; or press Alarm to go directly to the Alarm menu.
3.Use Up/Down arrows to highlight Alarm. Press Alarm to enable/disable the alarm.
An icon will be displayed on the left when the alarm is enabled, and the alarm will sound at the set time.
Waking to the iPod
1.Use the steps under Alarm Setting and choose “iPod” as the source.
2.On your iPod, choose the song you would like to awaken to and press Play.
3.Set the volume level on the JBL On Time™ 200ID unit.
4.Put your iPod to sleep by holding down the Play/Pause button (older iPod models may vary).
5.The JBL On Time 200ID system can be put to sleep by pressing the Power button.
Power
Alarm | Source |
Preset
Select Up
Menu/Up Level | Enter |
Select Down
Note: If you choose the last song on your iPod, please place the iPod in repeat mode, which will ensure that the iPod will continue playing past the last song.
