PAINTING THE CVIW50 FRAME & GRILLE
INSTALLATION
The JBL Cinema Vision
JBl CVIW50 can be painted
to match any decor. If you wish to change its color, the satin finish on the grille and frame will function as a primer coat. If CVIW50 is to be painted, please do it before assembling a CVSAT50 or CVCEN50 onto this adaptor.
Before painting, install the paint shield (in the assembly kit) securely into the recess in the baffle. This will protect the speaker components and baffle from paint residue. Use a
Be certain the grille perforations remain free of paint. Filling them with paint will diminish the sound quality.
NOTE: Gently remove the acoustical foam blanket from the grille before painting. Reattach the blanket after the paint has dried.
Tools Needed
Pencil | Phillips #2 screwdriver |
| |
Measuring tape | Awl |
EXISTING CONSTRUCTION
Utility knife
Carpenter’s level
ASSEMBLING A CVSAT50 OR CVCEN50 ONTO CVIW50
51
2
Level
Template
³1/2"
³1/2"³1/2"
3
4
7
| 3 |
6 | 4 |
5 |
1.Mount CVSAT50 or CVCEN50 loudspeaker to CVIW50 adaptor as instructed earlier in this installation guide.
Determine the correct speaker location. Note: Remove the inner template, which is the paint shield, at the perforation. Also remove the other perforation from the cardbord part until you are left with a card- board frame. Confirm that this card- board frame comfortably fits on the back of the CVIW50 frame. This will be the opening size of your installation cutout in the drywall. Although the adaptor may be oriented either horizontally or vertically, the installation procedure is the same.
NOTE: always allow at least
Note: If the CVIW50 frame and/or grille are to be painted, please do it before assembling the loudspeaker onto the CVIW50.
1.Place the frame (1) on a flat surface. Use a non abrasive surface as to not damage the finish of the frame.
2.Position the CVSAT50 or CVCEN50 loudspeaker (2) on the frame (1). The four pins on the CVIW50 frame (5) should be inserted into the four
3.Position each of the two braces (3) on the back of the loudspeaker (2) enclosure, and securely attach brace (3) to frame (1) using 4 small bolts
(4) per frame.
4.Remove mounting bracket (7) and store bracket and screws for possible future use.
5.Do not attach grille (6) until after the assembly is installed in a wall.
2. Cut the drywall. | Connect the speaker wires | Place the frame assembly |
| to the speaker. | in the wall. |
3. Screw down each of the 8 phillips | Replace the metal grille. Attach |
head screws. The locking tabs will | the JBL logo to the grille to |
swivel into place and will secure the | correspond to vertical or |
unit to the rear surface of the drywall. | horizontal installation. |
2 | 3 |