9.Fuse – 40 Amp ATC type fuse for the GTS300 and two 40 amp fuses for the GTS600.
10.Gain Control – Use this control to adjust the input sensitivity of the amplifier. See the “Adjusting the Gain” section for tips on proper setup.
11.
12.Speaker Output Crossover Switch – This switch controls the
pass filter on the amplifier (for subwoofer use). Set the switch to “High Pass” to activate the high pass filter for use with satellite speakers.
13.Input Mode Selector – This switch is used to set the input mode for both preamp and
Set this switch to Stereo for normal operation using both left and right inputs. Set this switch to R to drive both the left and right output channels with only a single input on the right channel. Set this switch to “L+R” to sum the left and right inputs for a mono output on both amplifier channels. Power Indicator LED (on chassis top) – LED steadily illuminates for normal operation. LED blinks when protection circuitry or muting is engaged.
14.Bass Boost Switch – This activates a
LINE
INPUT
L
R
➀Preamp Level RCA Inputs
➁Preamp Level RCA Outputs
➂High Level Speaker Inputs
➃Speaker Outputs
PREAMP
OUTPUT
L
R
SPEAKER
SPEAKER LEVELOUTPUT INPUT
+ | + |
|
|
R | L | + | + |
_ | _ | ||
|
| R | L |
|
| _ | _ |
BRIDGED
FUSE 40A
40A
POWER
REM IN
BATT(+)
REM OUT
GND
➄Remote Turn On Output
➅ Battery Ground | Power |
| |
➆ Battery (+12v) In | Connector |
|
➇Remote Turn On Input
➈Fuse
| BASS BOOST | INPUT MODE |
| SPEAKER OUTPUT |
| PREAMP OUTPUT |
|
| |
|
| CROSSOVER |
| CROSSOVER |
| NOM | |||
OFF | ON | R | L+R | FLAT | HIGH PASS | FLAT | HIGH PASS | ||
| |||||||||
|
| STEREO |
| LOW PASS |
| LOW PASS | MIN | MAX | |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| GAIN | |
|
|
|
|
|
|
|
| ➉ Gain Control | |
|
|
|
|
|
|
|
| Preamp Crossover Frequency Selector | |
|
|
|
|
|
|
|
| Amplifier Crossover Frequency Selector | |
|
|
|
|
|
|
|
| Input Mode Selector | |
|
|
|
|
|
|
|
| Bass Boost | |
|
|
|
|
|
| 3 |
|
|