
L226W, LS326W
≥1/2"
≥1/2"
≥1/2"
1.Remove the plastic paint shield from the speaker frame.
5.Connect the speaker wires to the speaker.
2.Determine the correct speaker location. NOTE: Use the included template when cutting the drywall.
6.Make sure all four locking tabs are properly positioned against the locking tab stops that are located on the speaker frame (see Figure 6 below). After confirming this, carefully place the frame assembly in the wall and confirm that there is no more than
Figure 6.
3. NOTE: Always allow
at least a 1/2 inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.
7.Screw down each of the four
4.Ensure that the drywall or plywood board or other appropriate wallboard is at least
8.Attach the metal grille and logo, if desired.
5