PLACEMENT

SPEAKER CONNECTIONS

NOTE: In all applications, the tweeter and dual midrange drivers should be

CONNECTION TIPS

aimed toward the listening area.

 

STEREO

Before deciding where to place your speakers, survey your room and think about placement, keeping the following points in mind, and using Figure 1, on previous page, as a guide:

For best results, place the speakers 6'–8' apart.

Refer to “Home Theater” below if you also plan to use the speakers in a home theater system.

HOME THEATER

For front-channel use, place one speaker on the left and another on the right along either side of the television.

A center channel speaker should go directly above the television. For left and right surround channels, place one speaker on the left and another on the right, to the side of or slightly behind the listening area. In 6- or

7-channel configurations, place the rear channel(s) behind the listening position, as shown in Figure 3.

NOTE: A JBL powered subwoofer will add impact and realism to both music and film soundtracks. Contact your JBL dealer for recommendations on subwoofer models for your application.

Proper placement of the speakers is an important step in obtaining the most realistic soundstage possible. These recommendations are for the optimal placement of the loudspeakers. Use these placement recommendations as a guide. Slight variations will not diminish your listening pleasure.

INSTALLATION

NOTE: The LS360C in-ceiling speaker was designed to be easily installed. However, if you are unable to clearly and fully understand and follow the instructions in this manual, or if you are unsure of your ability to properly install these loudspeakers, please contact your dealer or a qualified installer.

TOOLS NEEDED

Pencil

Phillips #2 screwdriver

 

(Do not use a powered screwdriver

 

of any kind)

Measuring tape

Utility knife

Figure 4.

 

Wire Length

Recommended Size

Up to 100 ft.

16-gauge

Greater than 100 ft.

12-gauge

TURN OFF ALL POWER

Before completing the installation, you must connect your speakers to your system. First, turn off all audio-system power. Use high-quality speaker wire to make your connections. Use at least #16-gauge speaker wire with polarity coding. Heavier-gauge wire is recommended for larger distances. Consult the chart above or your dealer for recommendations. The side of the wire with a ridge or other coding is usually considered positive (+) polarity. Also, consult the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures.

Observe polarities when making speaker connections, as shown in Figure 4. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the – (black) terminals in the same way.

IMPORTANT!

 

 

Do not reverse polarities (i.e., + to – , or – to +) when making connections.

 

 

Doing so will cause poor imaging and diminished bass response. Be certain

Carpenter’s level

Awl

that positive and negative wire strands are completely isolated to avoid short

circuits that may damage your equipment.

 

 

3

Page 3
Image 3
JBL LS360C manual Placement Speaker Connections, Installation, Stereo, Home Theater, Turn OFF ALL Power

LS360C specifications

The JBL LS360C is a prominent model in the realm of high-performance in-ceiling speakers, making it an ideal choice for audiophiles, home theater enthusiasts, and music lovers alike. This speaker is designed to deliver exceptional sound quality while seamlessly integrating into any living space.

One of the main features of the JBL LS360C is its sleek and unobtrusive design. The speaker boasts a low-profile appearance, allowing it to blend into its surroundings without compromising on audio performance. Its paintable grille further enhances its versatility, letting homeowners match the speaker to their interior decor.

In terms of sound quality, the LS360C excels with its advanced driver technology. The speaker features a high-output 6.5-inch PolyPlas woofer, engineered to provide a rich and full-bodied bass response. This ensures that users experience the depth and clarity of sound across all frequencies, making it an excellent choice for various audio applications. The LS360C also includes a 1-inch titanium tweeter, which helps deliver sparkling highs and an expanded soundstage, resulting in a crisp and detailed listening experience.

The LS360C integrates JBL's proprietary technologies, including the Harman Balancing Act design. This technology optimally positions the speaker’s components to ensure a balanced sound output, no matter the listener’s position in the room. Additionally, the speaker uses a Surround Sound technology that enhances its performance in multi-channel audio setups, providing an immersive listening experience that is perfect for both movies and music.

Another stand-out characteristic of the LS360C is its ease of installation. The speaker is equipped with a patented SureGrip mounting system, which allows for quick and secure placement in various ceiling types. This feature simplifies the installation process for homeowners and professionals alike, enabling them to enjoy their new audio system without the hassle.

In summary, the JBL LS360C is a high-quality in-ceiling speaker that combines excellent audio performance, innovative design, and user-friendly installation features. Whether used in a home theater setup or a whole-house audio system, the LS360C is designed to deliver an exceptional auditory experience that captivates listeners and elevates their enjoyment of music and sound. With its blend of cutting-edge technologies and aesthetic appeal, the JBL LS360C stands as a strong contender in the world of home audio solutions.