JBL N24AW, N26 If there is no sound from, Any of the speakers, Volume is increased, Sound coming

T R O U B L E S H O O T I N G

If there is no sound from				If the system plays at low
any of the speakers:				volumes but shuts off as
• Check	that receiver/			volume is increased:
amplifier is on and			that a	• Check all wires and
source is playing.				connections between
• Review proper operation				receiver/amplifier
				and speakers.
of your receiver/amplifier.
				• Make sure all wires are
If there is no		sound coming		connected. Make sure none
				of the speaker wires are
from one speaker:
				frayed, cut or punctured.
• Check the “Balance”
				• If more than one pair of
control on your receiver/
				main speakers is being
amplifier.
				used, check the minimum
• Check all wires and
				impedance requirements of
connections between				your receiver/amplifier.
receiver/amplifier
and speakers.				If there is no (or low) bass
• Make sure all wires are
				output:
connected. Make sure none
				• Make sure the polarities
of the speaker wires are
				(+ and –) of the left and right
frayed, cut or punctured.
				“Speaker Inputs” are
				connected properly.

If there is no sound from the center speaker:

•Make sure that your receiver’s “Center-Channel” mode is in the ”Normal“ or ”Wide“ position. If it is in the ”Phantom“ position, the center speaker will not play.

•Check all connections between processor/ amplifier and the center speaker.

Declaration of Conformity

We, JBL Europe A/S

Kongevejen 194B

DK-3460 Birkerød

DENMARK

declare in own responsibility, that the loudspeakers

described in this owner’s manual are in compliance with

technical standards

EN 50081-1:1992

EN 50082-1:1992

Steen Michaelsen

JBL Europe A/S

Birkerød. DENMARK. 8/99