
INSTALLATION
CONNECTIONS
Figure 5. Mounting the tweeter using the I-Mount flush-mounting kit.
1)push in
4)
blk –
+
red
3)
Open the crossover housing by firmly squeezing the sides of the top half and lifting it away from the bottom. Using screws or a wire tie, mount the crossover using the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in Figures 8A and 8B. Replace the cover when you are finished making the connections and adjustments (see following section).
The Power Series component crossover features a
If a reduced tweeter output level is desired, carefully
2) turn
Figure 8A. Wiring connections on the crosssover network (shown with cover on).
remove the small plastic jumper from the pins marked “0dB” and place it across the two pins marked
Figure 6. Aiming the tweeter at a desired listening position.
3. Rotate to aim angled tweeter toward listener.
1. Slide screw up or down to adjust tweeter angle.
2.Tighten nut and washer to lock angle settings.
4. Securely tighten the large hand nut.
Figure 7. Mounting the tweeter using the I-Mount surface-mounting kit.
blk –

+ red
1
Red
To AMPLIFIER
SPEAKER OUTPUTS To WOOFER Blk ToTWEETER
Figure 8B. Locating wiring connections on the P552 woofer. Other woofers are wired similarly.
|
| P550C POWER |
|
| 2R0 |
|
|
R2 |
|
|
|
PTC | LP135 L1 | 0.15mH*0.7R | MT2.2u |
| R1 |
|
|
12u |
| 2R0 |
|
|
|
|
C2 | 0.08mH*0.7R | 0dB |
| L2 | |
|
|
In- In+ W- W+ T- T+
C1
Jumper
0dB
Flat
0dB
Big Lug = 2
Small Lug =