JBL PSW-D112 setup guide Subwoofer Output/LFE

2)If your receiver/amplifier has subwoofer outputs or preamp output jacks for the left and right channels.

3)If your receiver/amplifier has a single (mono) sub- woofer output or LFE out- put, you may connect the output to either the Left or Right line-level input on the subwoofer. However, to maximize the subwoofer’s performance, we recommend that you

use a “Y”-connector (not included). Plug the single male end of the “Y”-con- nector into the subwoofer output on the receiver/ amplifier, and connect each of the 2 female con- nectors to an RCA-type interconnect cable. Then connect the 2 intercon-

nect cables to the Left and Right line-level inputs on the PSW-D112.

Note: If your receiver/proces- sor contains Dolby* Digital or DTS® surround processing technology, then set the “Low-Pass” control on the 180Hz position.

120

90150

High

60180 Pass

SPKR In		Phase
L	180	0
		120
R	90	150
		Low
	60	180 Pass
L	L	R Out	RECEIVER/AMPLIFIER
		Line Level		SUBWOOFER OUT
	L	R In
R				LEFT	RIGHT
SPKR Out
			MAIN SPEAKER OUTPUT
		RIGHT	+	–	–	+	LEFT
Power
On
Off	PSW-D112
	Digital Amplification
		+	–			–	+
		RIGHT				LEFT
		LOUDSPEAKER				LOUDSPEAKER

RECEIVER/PREAMPLIFIER

Subwoofer

Output/LFE

		120
	90	150
			High
	60	180	Pass
SPKR In		Phase
L	180	0
		120
R	90	150
			Low
	60	180	Pass
L	L		R Out
		Line Level
R	L		R In
SPKR Out
Power
On
Off	PSW-D112
	Digital Amplification

– 4 –