4
APPLICATIONS – Px600.2
The JBL Px600.2 amplifier can be
set up for stereo or bridged-mono
operation, as shown in Figures 4 and 5.
NOTE: For simplicity, Figures 4 and 5
do not show power, remote and input
connections.

Px600.2

(rear panel)
POWER FUSES
GND REM BATT
SPEAKER OUTPUTS
BRIDGED
STEREO
Px600.2
LR
NEON NEON
Subwoofer (4 ohms or greater)
Set MODE to LP;
INPUT MODE to MO
(on input panel)
X-OVER
ST
INPUT
MODE
MODE
SLOPE
MO
12dB 24dB
FLAT HP LP
32Hz 320Hz
FREQ
See “Setting the Crossover(s)”
onpage 6 to set FREQ and SLOPE
ForStereo or Mono signals, use 
both L/R inputs

Px600.2

(rear panel)
POWER FUSES
GND REM BATT
SPEAKER OUTPUTS
BRIDGED
STEREO
Px600.2
LR
NEON NEON
RSpeaker LSpeaker
Set MODE to FLAT; 
INPUT MODE to ST
(on input panel)
X-OVER
ST
INPUT
MODE
MODE
SLOPE
MO
12dB 24dB
FLAT HP LP
32Hz 320Hz
FREQ
FREQand SLOPE have no effect
Figure 4.The JBL Px600.2
amplifier is set to stereo mode
to drive a pair of full-range
speakers.
Figure 5.The JBL Px600.2
amplifier is set to bridged
(mono) mode to drive a single
subwoofer. Use this mode only
when the nominal impedance
of the subwoofer is 4 ohms
or greater.