JBL SCS-SAT500 manual Wall-Mounting

WALL-MOUNTING

4			and the back of the Satellite
			Speaker ¶, using large
	3	2
			needle-nose pliers until it is
		1	firmly seated against the back
			of the Satellite Speaker ¶
			and has locked the Ball and
			Shaft £ and the Satellite
8			Speaker ¶ together.
	5		NOTE: Once the Metal Nut ¡
			is fully tightened, it may embed
			some marks on the back of the
Important Safety Note: The		Step 3: Slide the Molded Nut	Satellite Speaker ¶. However,
customer is solely responsi-		™ onto the Ball and Shaft	these marks will be covered
ble for proper selection of		£ with the threaded open-	by the Metal Nut ¡.
mounting hardware not		ing facing the ball. Thread	Step 6: Mount the Attach-
included with the speaker,		the Metal Nut ¡ all the way	ment Plate ¢ into a wood
and for proper assembly		onto the Ball and Shaft £,	stud on the wall, using four
and installation of the wall-
mount bracket, including but
not limited to the selection of
appropriate weight-bearing			7
supports and proper use of
the bracket. JBL disclaims			6
any liability for the selection			1 2
of mounting hardware			3	4
and/or bracket installation.
Be sure to follow these
bracket assembly and			5
installation instructions
			8
carefully. If you have any
questions or doubts about		with the star washer side	#10 panhead wood screws
your ability to correctly wall-
mount the speakers, consult		away from the ball. Refer to	• at least one inch long
your authorized JBL dealer		the exploded drawing for the	(not supplied). Make sure
or custom installer.		proper orientation of these	that all four screws are
Step 1: Unscrew and remove		parts.	driven into the stud and not
		Step 4: Screw the Ball and	into drywall. If the bracket
the large Molded Nut ™. If
		Shaft £ into the Threaded	needs to be mounted in
necessary, use the supplied
		Insert § on the back of the	drywall, the customer is
Metal Bar ∞ as a lever by
		Satellite Speaker ¶ until it	responsible for selecting
inserting it into one of the
		is fully seated in the Threaded	and using appropriate wall
holes in the outer edge of
		Insert §, but do not tighten,	anchors and screws.
the Molded Nut ™.
		as you might dislodge the	IMPORTANT NOTE: The Metal
Step 2: Firmly grasp the Ball
		Threaded Insert §. Such	Nut ¡ must be fully tight-
and Shaft £ and pull it
		damage would not be cov-	ened against the Satellite
straight out of the Attach-
		ered under the warranty.	Speaker ¶ as described in
ment Plate ¢. Avoid leaning
		Step 5: Tighten the Metal Nut	Step 5 before beginning Step
it to the side for leverage, as
		¡ with the star washer side	7, in order to avoid damage
this may break off a tab.
		between the Metal Nut ¡	to the Threaded Insert §.

4