JBL SP5, SP6CS, SP8C manual Existing Construction, Remove the grille from, Location

EXISTING CONSTRUCTION

SP5, SP6, SP8

	ENGLISH
	≥1/2"
≥1/2"	≥1/2"

Remove the grille from the	Determine the correct speaker	Note: Always allow at least
speaker frame by pulling on the	location.	one-half inch between a wall
paper tab. If the tab is missing,	Note: Remove the inner tem-	stud and the speaker cutout or
to avoid scratching the grille or	plate, which is the paint shield,	the locking tabs will not be able
baffle you may unfold a paper	at the perforation. Use the	to swivel into place.
clip, insert the straight end	outer template when cutting
through one of the holes in the	the drywall.
grille, and gently pull up.

Cut the drywall.

Screw down each of the four Phillips head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.

Connect the speaker wires to the speaker.

The SoundPoint speakers fea- ture unique swivel mounts for the tweeters that enable you to aim the very directional high frequencies toward the listen- ing position, at ear-level height. Before installing the speaker grille, gently press on the outer edge of the tweeter mount to adjust the position of the tweeter. The tweeter will not swivel more than 15 degrees in any direction; do not attempt to force it to move further. You may also rotate the tweeter to orient the JBL logo as desired.

Place the frame assembly in the wall.

Replace the metal grille.

5