MTS-8000 Tester

3

Transport Configuration

SecondaryPortBank•10/100/1000 Mb/s Ethernet•1 GigE Tx/Rx (850 nm, 1310 nm, 1550 nm)
PrimaryPortBank

 

• 2.5 Gb/s, 622 Mb/s, and 155 Mb/s SDH/SONET

 

Tx/RX (1310 nm, 1550 nm)10Gb/sPortBank
• 10/100/1000 Mb/s Ethernet• 10 Gb/s SDH/SONET (1310 nm, 1550 nm)
• 1 GigE Tx/Rx (850 nm, 1310 nm, 1550 nm)

• 10 GigE LAN & WAN (850 nm, 1310 nm, 1550 nm)

OpticalConnectionCheckInterfaces•High accuracy power meter•Continuous wave power source•Visual fault locator
PortBank#4

•T1 and E1 balanced and unbalanced Tx/Rx

PortBank#5•E3, DS3, STS-1, E4 Tx/Rx•STM-1 (e) Tx/Rx

TransportModule

•Contained in one 5 cm module–PDH / T-carrier interfaces includeDS1, E1, E3, DS3, E4, STS-1 and STM-1e

–SDH/SONET interfaces (1310 nm, 1550 nm) include 155 Mb/s, 622 Mb/s, 2.5 Gb/s, 10 Gb/s

–Ethernet interfaces (850 nm, 1310 nm and 1550 nm) include10/100/1000 Mb/s electrical and 1 GigE Optical–10 GigE LAN + WAN•Only 2.5 kg fully populated, total weight < 7 kg

•Fully scalable to meet your current and future needs

•Optical and electrical signal level measurements•Up to 2.5 hours at 10 Gb/s rates with one battery (2 batteries possible)•Field exchangeable connectors for all standard connector types
•SDH/SONET testing–Mixed payload generation and analysis–Concatenated signals–Automatic Protection Switching (APS)–Overhead byte manipulation and analysis–Round Trip Delay (RTD)•Ethernet testing–Single and dual port Ethernet configuration–Testing on Layer 1, 2 and 3 (IP)–VLAN support–Constant, burst and ramp traffic generation–Traffic filter capabilities–Automated RFC2544 testing–Loop-up /loop-down of far end device