7
PART PROCEDURE
CAUTION
Cleaning Procedures
•Be sure appliance is off and all parts are cool before handling or
cleaning. This is to avoid damage and possible burns.
• To prevent staining or discoloration, clean appliance after each use.
• If a part is removed, be sure it is correctly replaced.
Control Knobs • Remove knobs in the OFF position by pulling up.
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
• Turn on each element to be sure the knobs have been correctly replaced.
Fan Control • After removing air grille (see page 6), pop the knob up. Wipe with a clean cloth using soap and water.
Knob Rinse and dry thoroughly. Return knob to DOWN position, replace air grille.
Smoothtop - Never use oven cleaners, chlorine bleach, ammonia or glass cleaners with ammonia. Note: Call an authorized
Glass-Ceramic servicer if the glass-ceramic top should crack, break or if metal or aluminum foil should melt on the cooktop.
•Allow the cooktop to cool before cleaning.
•General – Clean cooktop after each use, with a damp paper towel and Cooktop Cleaning Creme*
(Part No. 20000001)**. Then, buff with a clean dry cloth.
Note: Permanent stains will develop if soil is allowed to cook on by repeatedly using the cooktop when soiled.
•Heavy Soils or Metal Marks – Dampen a “scratchless” or “never scratch” scrubber sponge. Apply
Cooktop Cleaning Creme* (Part No. 20000001)** and scrub to remove as much soil as possible. Apply a
thin layer of the creme over the soil, cover with a damp paper towel and let stand 30-45 minutes (2-3
hours for very heavy soil). Keep moist by covering the paper towel with plastic wrap. Scrub again, then
buff with a clean dry cloth.
Note: Only use a CLEAN, DAMP “scratchless” pad that is safe for non-stick cookware. The
pattern and glass will be damaged if the pad is not damp, if the pad is soiled, or if another type of
pad is used.
•Burned-on or Crusty Soils – Scrub with a “scratchless” or “never scratch” scouring pad and
Cooktop Cleaning Creme*. Hold a razor blade scraper at 30° angle and scrape any
remaining soil. Then, clean as described above.
Note: Do not use the razor blade for daily cleaning as it may wear the pattern
on the glass.
•Melted Sugar or Plastic – Immediately turn element to Lo and scrape sugar or
plastic from hot surface to a cool area. Then turn element OFF and allow to cool.
Clean residue with razor blade scraper and Cooktop Cleaning Creme*.
Ventilation Area • See page 6.
* Brand names for cleaning products are
registered trademarks of the respective
manufacturers.
** To order direct, call 1-800-JENNAIR
(1-800-536-6247).
CARE & CLEANING8111P486-60 5/18/06, 4:02 PM8