| 4 of 4 |
DOWNDRAFT SLIDE-IN RANGE DUCTING ARRANGEMENTS
DUCTING CONFIGURATIONS
5" (12.7 cm)
diameter duct
5" (12.7 cm) diameter
to 31⁄4" x 10"
(8.3 cm x 25.4 cm)
transition elbow
REAR DUCTING IN WALL TO ROOF
DUCTING REQUIREMENTS
range | duct length | duct size | |
|
|
| |
| 10' (3.0 m) or less* | 5" (12.7 cm) | |
| diameter* | ||
|
| ||
|
|
| |
Dual Fuel, |
| 6" (15.2 cm) | |
Gas | Between 10' (3.0 m) | diameter | |
| and 60' (18.3 m) | 31⁄4" x 10" | |
|
| (8.3 cm x 25.4 cm) | |
|
|
| |
| 10' (3.0 m) or less** | 5" (12.7 cm) | |
| diameter** | ||
|
| ||
|
|
| |
Electric |
| 6" (15.2 cm) | |
Between 10' (3.0 m) | diameter | ||
| |||
| and 60' (18.3 m) | 31⁄4" x 10" | |
|
| (8.3 cm x 25.4 cm) | |
|
|
|
*Dual fuel ranges must use 5" (12.7 cm) diameter for runs of 10' (3.0 m) or less.
**May be used to vent straight out the back of the range and directly through the wall.
5" (12.7 cm)
diameter duct
5" (12.7 cm)
diameter wall cap
REAR DUCTING THROUGH WALL TO OUTSIDE
6" (15.2 cm)
diameter elbow
SIDE DUCTING IN TOE KICK TO OUTSIDE
CALCULATING MAXIMUM DUCTING LENGTH
•Maximum ducting length is 60' (18.3 m).
•Each 90° elbow equals 5' (1.5 m) duct.
•Use no more than three 90° elbows.
•Flexible metal vent is not recommended.
•Do not install two elbows together.
NOTES:
•For ducting runs up to 30' (9.1 m), install range as shipped.
•For ducting runs of 31' (9.4 m) to 60' (15.2 cm), remove the restricter ring on the blower inlet housing.
•For altitudes above 4500' (1272.0 m), reduce recommended vent run by 20% for best performance.
5" (12.7 cm) 
to 6" (15.2 cm)
diameter
transition elbow
6" (15.2 cm)
diameter wall cap
THROUGH FLOOR between joists TO OUTSIDE
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing | JRC120053 03/2012 |
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary. |
