Jenn-Air JRC120012A dimensions Opening/Clearance Dimensions, Jenn-Air Detailed Planning Dimensions

JENN-AIR®DETAILED PLANNING DIMENSIONS 2 of 4

36" jx3™ Gas Downdraft Cooktop

JGD3536W – 36" x 183⁄8" x 211⁄2"

OPENING/CLEARANCE DIMENSIONS

A

	E*
				F
B				B
			G	H
				I
		v		e
	C			D
		v	J**
				K
	C

FRONT VIEW

MODEL #		JGD3536W
		in	cm
A	Width of combustible area above	36	91.4
	cooking surface (min.)
B	Width from cooktop to fixed wall	6	15.2
	or other combustible material (min.)
C	Width to center of vent opening option	171⁄2	44.4
D	Width to outer edge of outlet	10	25.4
E*	Height to bottom of uncovered wood or	30	76.2
	metal cabinet above cooking surface (min.)
F	Height to bottom of uncovered wood	18	45.7
	or metal cabinet (min.)
G	Height to center of vent opening option	16	40.6
H	Height to top edge of outlet (min.)	12	30.5
I	Height to top of gas installation area	6	15.2
J**	Depth to center of vent opening option	171⁄8	43.5
K	Depth of gas installation area	6	15.2
L	Depth of upper cabinet (recommended)	13	33.0
M	Depth from cutout to wall (min.)	2	5.1
N	Width of cutout	343⁄4	88.3
O	Depth of cutout	20	50.6
P	Depth from cutout to front of countertop	21⁄8	5.4
e	Recommended electrical access location
g	Recommended gas supply line location
v	Recommended venting location –
	see pages 3-4 for ducting information

  *Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet is covered by not less than 1⁄4" (0.6 cm) flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

**Based on installation in a 24" (61.0 cm) base cabinet.

Side

Cabinet

L

M

GAS REQUIREMENTS

Natural Gas

This cooktop is factory-set for use with natural gas.

LP Gas Conversion

Conversion must be done by a qualified service technician. To convert to LP gas, use the LP gas conversion kit provided with the cooktop.

ELECTRICAL REQUIREMENTS

120 volt, 60 Hz, AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or dedicated circuit is recommended.

VENTING REQUIREMENTS

This cooktop must be exhausted outdoors unless using the duct-free filter kit (JDA7000WX). Refer to kit instructions for further information.

LOCATION REQUIREMENTS

•To ensure cooktop base clearance, cabinet side walls need to be wider than the cutout.

•A minimum clearance of 2" (5.1 cm) is recommended between the blower motor and cabinet for proper cooling. A 6" (15.2 cm) clearance is recommended for servicing access.

•An under counter built-in oven cannot be installed under this cooktop.

N M

O

P

Side VIEW	TOP VIEW – cutout
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing		JRC120012A 07/2012
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.