Jenn-Air W10300216A Select a Cycle cycles vary by model, Select Options options vary by model

■ Fresh automatic	A
dishwasher detergent
results in better	Hard Water	Hard Water
cleaning. Store tightly	Soft Water
		Soft Water
	B
closed detergent
container in a cool, dry		PRE-
	MAIN WASH	WASH
place.

NOTE: For most water conditions, the factory setting of 2 will give good results. If you have hard water or notice rings or spots, try a higher setting. Turn

Cthe arrow adjuster inside the dispenser by either using your fingers or inserting a flat-blade screwdriver into the center of the arrow and turning.

	-	-	6	5	4
	-
	fill
max					3
						2
-						1
-
-						-
-
	-				-
		-	-	- -
	-

A. Cover latch

B. Main Wash section

C. Pre-Wash section

■The amount of detergent to use depends on:

How much soil remains on the items - Heavily soiled loads require more detergent.

The hardness of the water - If you use too little in hard water, dishes won't be clean. If you use too much in soft water, glassware will etch.

Soft to Medium Water (0-6 grains per U.S. gallon) [typical water softener water and some city water]

Medium to Hard Water (7-12 grains per U.S. gallon) [well water and some city water]

■Depending on your water hardness, fill the Main Wash section of the dispenser as shown. Fill the Pre-Wash section to the level shown, if needed.

NOTE: Fill amounts shown	Hard Water
are for standard powdered
	Soft Water	Hard Water
detergent. Follow instructions		Soft Water
on the package when using	Main Wash	Pre-Wash
other dishwasher detergent.

STEP 3

Select a Cycle (cycles vary by model)

See “Cycle and Option Descriptions” charts in the following section.

Heavier cycles and options affect cycle length. Some cycles and options will take up to 3¹⁄₂ hours to complete.

Select Options (options vary by model)

See “Cycle and Option Descriptions” charts in the following section.

You can customize your cycles by pressing the options desired.

Add Rinse Aid

■Your dishwasher is designed to use rinse aid for good drying performance. Without rinse aid your dishes and dishwasher interior will have excessive moisture. The heat dry option will not perform as well without rinse aid.

■ Rinse aid keeps water from forming droplets that can	Full
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.

■Rinse aid helps to reduce excess moisture on the

dish racks and interior of your dishwasher. Add

■Check the rinse aid indicator. Add rinse aid when indicator drops to “Refill” level.

■ To add rinse aid, turn the dispenser cap			Lock
to “Refill” and lift off. Pour rinse aid into
the opening until the indicator level is at			-		5
“Full.” Replace the dispenser cap and				-
			-				43
turn to “Lock.” Make sure cap is fully		max	fill
	Refill							2
locked.		-						1
		-
		-						-
		-
			-				-
				-	-	-

STEP 4

Start or Resume a Cycle

■Run hot water at the sink nearest your

dishwasher until the water is hot. Turn off water.

■Press START/RESUME and close the door

within 3 seconds. The door latches automatically. Press START/RESUME to repeat the same cycle and options as in the previous wash cycle.

■You can add an item anytime before the main wash starts. Open the door slowly and add the item. Press START/RESUME and close the door within 3 seconds.

¹⁄₄ turn to lock

4