• For PVC & Inflatable Vinyl Buoys and floats |
• Chemically bonds with the buoys for highest durability |
• Colorfast & UV resistant | NEW! |
• Oil & gas resistant | |
• High visibility | | |
• Superior adhesion- won't crack | |
• Commercially used and proven | |
• The choice of commercial fisherman worldwide |
• Rugged durability | | |
Please Specify Color: Green, Blue, Red, Orange or White |
Item | Ship | Quart |
G 751325 | 3 lbs | $18.99 |
AquaGard® 190 Waterbased Primer
• For Aluminum or Wooden Surfaces | | | ! |
• Chemically bonds to aluminum | | |
| | | |
• Excellent resistance to corrosion and salt | EW |
N | |
• Improves adhesion of final coat | | | |
• Compatible with all other top coats | | |
• Formulated for use with Alumi-Koat Antifouling Paint | |
• Exceeds VOC standards | | | |
• No toxic fumes | | | | |
• Waterbased | | | | |
• Cleans up with soap and water | | | |
Item | Model | Ship | Quart | |
G 751326 | 25009 | 3 lbs | $24.99 | |
Shockles Portable Solar | ! |
Powered LED Light | NEW |
|
The solar powered RailLight™easily attaches to railings on boats, RVs, decks and much more. Are you looking for solar powered light you can mount anywhere? The tough, secure rail clamp will quickly fasten and unfasten to any rail without scratching the finish and you can adjust the angle and height to match your space and needs or use the larger transom clamp
that attaches in either a horizontal or vertical position and will quickly secure the RailLight to any edge up to two inches thick.There's a so you can easily turn off the RailLight if you want total darkness.
•Made from coated stainless steel to resist corrosion and provide years of service
•Sturdy, lightweight and waterproof
•Solar panel is designed for many years of use
•Bright white LEDs will last for over 10,000 hours
•Charge up the RailLight outside during the day and use it inside your boat at night
•Easily attaches to railings from 3/4” to 1 1/4”
•Comes complete with two types of clamps:
-Circular rail clamp that will easily clip onto any round rail
-Larger transom clamp that attaches in either a horizontal or vertical position and will quickly secure the RailLight to any edge up to two inches thick
•Attaches in seconds; no wires, no batteries, no costly installation
•Small, weather-protected on/off switch
Item | Model | Ship | | | Net |
700367 | 5201 | 1 lbs | | | $26.95 |
Maretron Simnet to | | | ! |
| | | |
| | | W | |
NMEA 2K Cable Adapter | | NE | | |
| | | |
The Simrad SimNet Product to NMEA 2000® Network Adapter Cable, manufactured by Simrad, is used to connect a Simrad SimNet product like the NMEA 2000®/NMEA 0183 Adapter (AT10) or CX NavStation Series products to an NMEA
2000® network.The cable is 0.5 meters in length and has a female SimNet connector on one end and a standard male NMEA 2000® Micro Series connector on the other end.
Item | Model | Ship | Net |
256928 | 24005729 | 1 lbs | $89.99 |
Watercounter™ Water
Management System
Allows you to:
• Accurately check the capacity of your tank.
• Preset the capacity of your tank in the Digital Display
• When you top off your tank and press the reset button, the tank's capacity is displayed.
• As you use water the Digital Display counts down (by gallons) to zero.
• A preset reserve can be established (if desired).
• Track water usage from several tanks with only one gauge.
Watercounter™ comes to you with the Computerized Digital Display formatted to read from zero up when the reset button is pushed.This allows you to find out how much water you can draw from your tank. Once this is determined (by topping off and using the water until the tank is empty) you simply reset the digital display to count down and change the zero set point to whatever is the gallon capacity of your tank. Each time the tank is topped off and the reset button is pushed the display shows the capacity of your tank and counts down (as gallons are used) always showing exactly how many gallons of water you have.
Item | Model | Ship | Net |
501237 | WC1 | 3 lbs | $285.00 |
SCADtech SensiStat Energy | ! |
Saver Refrigeration | |
| NEW |
Controller
Works with your 12 or 24-volt holding (aka holdover) plate refrigeration system and reduces your battery usage by:
1.Providing extremely precise thermal control thus reducing excess running of your refrigeration compressor
2.Automatically utilizing available “excess” power while your batteries are charging.This reduces the amount of battery energy used each day for refrigeration and saves you hours of battery charging time each week.This savings translates to real dollars as you will use less fuel for battery charging and reduce wear-and-tear on your engine or generator.
How it works:
A typical thermostat turns on your refrigeration compressor to freeze holding plates solid. The plates are then allowed to defrost to a temperature approximately 8o F higher before the compressor is turned on again and the plates are refrozen.The difference between the freezing temperature and the “defrosted” temperature is known as hysteresis or differential.This is the most energy efficient method and the more precise the control, the more efficient the system and the more likely your ice cream will remain solid. The SCADtech SensiStat refrigeration controller, with a resolution of 1/10o F provides unparalleled precision of control.What’s more, the SensiStat comes with temperature sensors to allow you to monitor and display both the holding plate temperature and refrigeration box temperature.
Normal thermostats also do not take advantage of randomly available “free” power provided whenever your engine or generator are running and charging your batteries. Since batteries can only charge so fast, there is normally plenty of extra generation capacity available to run your refrigeration system “for free”,that is using energy without depleting your batteries. When the SCADtech SensiStat refrigeration controller detects charging level voltages, it closes down the hysteresis to only 1o F and uses the available free power to “top-up” the freeze on your holding plates. For example, when you are motoring into an anchorage at the end of the day, The SensiStat will automatically run your refrigeration compressor while your engine is running and save you all the battery energy that would have been used later in the evening running the refrigeration compressor for the same amount of time directly off the batteries.
You can also tell the SCADtech SensiStat refrigeration controller to ignore extra power (such as while plugged in a dock) or to force a freezing of the holding plates for up to 60 minutes.
Additionally, the SCADtech SensiStat detects excess voltages which might damage your refrigeration system alerts you and does not over-ride the differential when excess voltages are present.
Finally,although the factory settings will work for most sailors,you can custom program the voltage threshold at which the SCADtech SensiStat overrides the differential.You can also set the holding plate freezing temperature, the normal and override differentials, the displayed temperature scale (Fahrenheit or Centigrade), and whether the holding plate or box temperature is displayed by default.
Item | Model | Ship | M.A.P. |
400694 | 10020 | 1 lbs | $298.95 |
