A222HLX Anlplifier
Inputs
Input Sensitivity Control
Adjust the sensitivity to the inpullevd
Crossover
Adiust the crossover to accomoda\e | Speaker Terminals | |
your chosen installation method. | ||
• | LPF==low pa~s filter | Connect to speakers. |
• | HPF==high pass filter |
|
• | Flat::=no filter. |
|
See Installation Alternatives on page 5.
Low Level Input RCA Connectors | High Level |
Connect RCA cables from YOOf receiver (if equipped) OR | Input Harness |
t(l these RCA jacks. For the least hamlOnic distortion, | Conncc! wircs from |
low level inputs are rc(;omnlcnJed. | your receIver's |
Important: | srcaker output 10 |
these wires. | |
Do not conm:ct both high kvd and lu.... level iHrUb |
|
to the ~ame inputs at the S<lme time |
|
Outputs and Power
Ground Terminal (GND) | Power Terminal | |
C()rlI1CC! (() <I \~{>Od chassi~ \'"fOund_ | ||
(+12V} | ||
The ;!round c~nne<:tion ~h;uld he to | ||
clcal~. unpainted meta! to provide:J | Connect directly !~, the | |
gcmJ electrical connection | ,·~hicle | |
| gauge wire (rni[llml~m) |
ruW~~~Jwr~~~~w~\====~/==~ -~.• ~~e /' e;~;TI, I~
~~''":::n @U i 2
me;
\
Remote Sensing Terminal (RMT)
Power Light
Thi~ rcd light comes on when
12volt and DC power are llv<lil- able at both {he baHt:ry + 12 voll Jnd sensing wires
Connect the radio power antenna k:Jd to the A222HLX power sensing tCrmin:J.l h.J lOrn the ,\mrlificron whenever th~ n:<.:~ivt:r IS lOrna:! on. If a powt:r antenna leLld is no! 3_ailable. <.:onneCI this wire 10 a +12 VDC source L~L1l i~ 5wlh:hed on with thc ignition
Fuse
Usc only
a 25 amp
blade·tn~
luse.
4