![](/images/new-backgrounds/1297120/2971205x1.webp)
PS475
Installation
This device is a
Supplies and Tools Needed
To install the amplifiers, you will need tools, supplies and adapters. It is best to make sure you have everything you need before you start.
Supplies
•Black electrical tape
•Amplifier Installation Kit
Tools
• | Cordless drill with assortment of bits |
• |
Routing Wires
Circuito de Ubicación de los Cables
Cablage
BATTERY
1
2 (+)
3
11
4
• | Wire cutters/strippers |
• | Crimping tool |
• | |
• | Wire brush, sandpaper or scraping tool (ground connection to vehicle should be a clean, |
| unpainted metal surface) |
Disconnect Battery
Disconnect the negative
Location and Mounting
The PS amplifier’s compact design allows great flexibility in mounting. Common mounting locations include under the front passenger seat or in the trunk area.
When selecting a location, remember that amplifiers generate heat. Select a location on a flat surface away from heat and moisture where air can circulate around the amplifier. Do not cover
5
RECEIVER
6
7
AMP
9
8
10
the amplifier with carpets or enclose it behind interior trim panels, and do not mount the amplifier in an inverted or upside down configuration. Be sure the mounting location and the drilling of pilot holes will not damage any wires, control cables, fuel lines, fuel tanks, hydraulic lines or other vehicle systems or components.
Place the amplifier in the mounting location, and mark the positions of the holes with a marker, pen or pencil. Carefully drill the mounting holes in the marked positions, and use the supplied mounting screws to securely fasten the amplifier to the mounting surface.
Routing Wires
Proper wiring connections are illustrated in the Routing Wires diagram. If wiring connections are made incorrectly, the unit will not operate properly and could become permanently damaged. Follow the installation instructions carefully, or have the installation completed by an experienced technician.
CHASSIS GROUND
1.Battery / Batería / Batterie
2.Battery Connector / Conector de Batería / Connecteur de la batterie
3.Fuse or Circuit Breaker / Fusible o interruptor de circuito / Fusible ou disjoncteur
4.Receiver / Receptor / Récepteur
5.RCA Cables / Cables de RCA / Câbles de RCA
6.Speakers / Altavoces /
7.Amplifier / Amplificador / Amplificateur
8.Ground Screw - Drill 1/8" hole in chassis sheet metal . Use the same ground if using multiple amplifiers.
Tornillo de Tierra - Ajugero del taladro en metal de hoja del chasis. Utilice la misma tierra si usa los amplificadores multiples. Vis Moulue - Trou du foret en métal de feuille de châssis. Employez la meme terra si à l’aide des amplificateurs multiple.
9.Power Antenna
10.Power Wire / Alambre de la energía / Fil de Puissance
11.Grommet (to prevent damage to power wire)
Arandela aislante (para preventir daño al alambre de la energía) Canon isolant (pour empécher des dommages au fil de puissance)
3