Jensen VR185 manual Mounting the Base, Installing the IR Sensor, Steering Wheel Remote Control

REMVR185KIT

Remote Control Kit

WB

VOLTUN/CH

MODE

BNDSAT

Strap

Screw

Mounting the Base

1.Detach remote from base/strap by pressing the release button and pull- ing up.

2.Remove the two screws on the base that appear when the remote is removed.

3.Position strap around steering wheel, and pull tight. Replace plate and screws.

4.Insert battery (Lithum 2032 3-volt) into remote contol, and reinstall the remote onto the base/strap.

Infrared Sensor

VR185

3.5mm Jack

(21/64 hole or 9.2 mm drill

Installing the IR Sensor

Select a mounting location close to the steering wheel, and drill a 21/64 hole for the 3.5

mm.jack to pass through. Route the infrared sensor wire through the hole, secure the sen- sor with double-sided sticky tape and connect to the car radio via the 3.5 mm. jack on the back of the unit.

Weather Band		Tuning/Channel
Volume	WB	Release Button
	VOL	TUN/CH
Mode

Band	MODE
BND	SAT

Strap

Satellite

Steering Wheel Remote Control

This remote control mounts to the steering wheel and operates the basic functions of the car radio, including volume, tuning, mode, band, satellite and weather band.