®
XA2150
Wiring
Power and Outputs
FUSE | + 12V | RMT | GND |
30A |
|
|
|
|
| POWER |
|
L + | L – | R – | R + |
SPEAKER 
Power Terminal (BATT +12V)
Connect directly to the vehicle battery+ terminal with 8 gauge wire (minimum).
+ 12V RMT GND
Remote Terminal (RMT +12V)
Connect the radio power antenna lead from the receiver to the amplifier REMOTE terminal. This turns the amplifier on whenever the re- ceiver is turned on. If a power antenna lead is not available, connect this wire to the radio or accessory fuse.
+ 12V RMT GND
Not Supplied
30 amp Fuse |
or Circuit Breaker |
Spade
Connector
8 Gauge
Spade
ButtConnector
Battery
Terminal
Adapter
Install as close |
to the battery |
as possible |
To Battery+
Terminal
Wire
Connector
(not supplied)
8 Gauge
To Receiver
Power
Wire
Antenna Lead
Ground Terminal (GND)
Connect to a good chassis ground. The ground connection should be to clean, unpainted metal to provide a good electrical connection.
+ 12V RMT GND
|
| Spade |
| Sheet Metal | Connector |
Ring | Screw |
|
(supplied) |
| |
Connector |
| |
|
| |
|
| 8 Gauge |
|
| Wire |
Drill 1/8" hole |
|
|
in chassis |
|
|
sheet metal |
|
|
Fuses
FUSE
Use only one 30 amp
30A
4
