Assembly
1.Install four casters to the under side of the base as pictured in Fig. 1. Thread the hex nut (B, Fig. 1) onto the caster shaft. Then slide the lock washer (A, Fig. 1) over the caster shaft. Thread the caster shaft into the threaded hole on the underside of the base, turn until snug. Tighten the nut (B, Fig. 1) against the base with a 14mm wrench. This will give the caster proper clearance.
2.Place the base with casters on the ground. Attach the motor and fan assembly (A, Fig.
2)to the base using four M8 x 16 hex cap bolts, four M8 flat washers (B, Fig. 2), and a 13mm wrench.
WARNING
The dust collectormust be disconnected from the power source during assembly. Failure to comply may result in serious injury!
3. Attach inlet guard (A, Fig. 3) to fan housing using eight M5 x 12 pan head screws (B, Fig. 3). Press the inlet port onto the inlet guard until it snaps into place.
WARNING
To reduce therisk of injury from moving parts, always keep inlet ports covered with the caps provided, if they are not connected to a flexible hose. Failure to comply may result in serious injury!
6
