Unpacking
1.Remove contents from the shipping box.
2.Inspect contents for shipping damage and report damage, if any, to your distributor.
3.Be sure to keep the box and packing material should you need to pack the lathe for moving.
4.Do not clean the lathe with anything other than a damp cloth or a mild solvent. Use of heavy solvents, paint thinner, gasoline, etc. will damage painted surfaces.
Contents of the Shipping Carton:
JML | ||
1 | – Lathe | 1 – Lathe |
1 | – 6” Tool rest | 2 – Tool rests (6”,10”) |
1 | – Face plate | 1 – Face plate |
1 | – Drift rod | 1 – Drift rod |
1 | – Live center | 1 – Live center |
1 | – Spur center | 1 – Spur center |
1 | – Safety goggles | 1 – Safety goggles |
1 | – Owner’s manual | 1 – Tool caddy |
1 | – Warranty card | 1 – Work lamp (bulb |
1 | – 3mm hex wrench | not included) |
1 | – 5mm hex wrench | 1 – Owner’s manual |
|
| 1 – Warranty card |
|
| 1 – 3mm hex wrench |
|
| 1 – 5mm hex wrench |
Assembly
The
The
If desired, the lathe can be bolted to a work table or stand by removing the rubber feet and inserting screws through the holes in the base. IMPORTANT: The table or stand should have an opening directly beneath the motor to prevent
A stand specifically made for the lathe is available from WMH Tool Group. See stock numbers on page 6 for ordering.
8
