Jet Tools M-708448 owner manual Assembly

Assembly

1.Remove all contents from the shipping container.

2.Clean all rust protected surfaces with a mild solvent. Do not use paint or lacquer thinner, gasoline, or mineral spirits; these will damage painted surfaces.

3.Attach the four rubber pads (A, Fig. 1) to the bottoms of the side panels with four 5/16” x 5/8” Screws, four 5/16” flat washers and four 5/16” hex nuts (B, Fig. 1). The hardware can be found in the bag with the rubber pads.

4.Attach the side panels (C, Fig. 1) to the front panel (D, Fig. 1) with four 5/16” x 5/8” hex cap bolts, eight 5/16” flat washers, four 5/16” lock washers, and four 5/16” hex nuts (E, Fig. 1). Hand tighten the hardware at this point.

Note: Assemble the stand up side down to make sure that the tops of the panels are flush.

5.Mount the shelf (F, Fig. 1) to the inside of the stand with two M5x10 pan head screws and two M5 lock washers (G, Fig. 1).

6.Finish stand assembly by attaching rear panel to side panels with four 5/16” x 5/8” hex cap bolts, eight 5/16” flat washers, four 5/16” lock washers, and four 5/16” hex nuts.

7.Make sure stand is sitting evenly on a level surface before tightening hardware.

WARNING

Main unit is￿heavy! Use great care and

adequate resources when lifting the unit up

onto the stand!

Failure to comply may cause serious injury

and/or damage to the sander and/or

property!

8. With the aid of another person, carefully lift the main unit out of the shipping box, and up onto the stand. Line up threaded holes in sander base with holes in stand.

9. Through the door in the cabinet attach main unit to stand with two 5/16” x 1-1/4” hex cap bolts, two 5/16” lock washers and two 5/16” flat washers.

8