JL Audio C2-650-XO, C2-650-02102009, C2-650cw Getting Started, Speaker Placement Considerations

C2-650 Specifications:

Woofer: Injection-molded, Mica-filled, Polypropylene Cone, Butyl Rubber Surround, 1 in. Voice Coil on Kapton® Former, Flat, Symmetrical Roll Spider, Ferrite Magnet

Tweeter: 0.75 in. (19 mm) Silk Dome, Ferrofluid Cooling / Damping, Neodymium Magnet

Crossover Networks: 1st Order Low-Pass Filter, 2nd Order High-Pass Filter, 3-Position Adjustable Tweeter Level, Premium Mylar® Capacitors Premium Air-Core Inductors

Continuous Power Handling: 60 Watts

Recommended Amp Power: 15-100 Watts per channel (RMS)

Efficiency: 91.0 dB @ 1W/1m 97.0 dB @ 1W/0.5m

Sensitivity: 94.0 dB @ 2.83V/1m

Nominal Impedance: 4 ohm

Frequency Response: 59 Hz - 22 KHz ± 3 dB

Included Components and Parts:

•Two C2-650cw 6.50-inch (165 mm) Woofers

•Two C2-075ct 0.75-inch (19 mm) Tweeters

•Two C2-650-XO Crossover Networks

•Two Flush-Mount Tweeter Fixtures

•Two Surface-Mount Tweeter Fixtures

•Two Metal Spring Clips for Tweeter Fixtures

•Two Grille Assemblies

•Two Self-Adhesive JL Audio Nameplates for Grilles

•Twelve #8 x 1.2 inch (30 mm) Sheet Metal Screws

•Four #6 x 1-inch (25 mm) Sheet Metal Screws

•Two 1.18-inch (30 mm) Machine Screws

•Eight Mounting Clips for Woofer Mounting

•Two 4.7 mm Female Crimpable Connectors

•Two 2.8 mm Female Crimpable Connectors

•Two 4.7 Male Crimpable Connectors

•Two 2.8 mm Male Crimpable Connectors

•Twelve Crimpable Spade Connectors

GETTING STARTED

•Turn off the audio system. It is also advisable to disconnect the negative (–) terminal of your vehicle’s battery whenever performing installation work.

•Before cutting, drilling or inserting any screw, check clearances on both sides of the planned mounting surface. Also check for any potential obstacles, such as window tracks and motors, wiring harnesses, etc. Check both sides of the

vehicle, many vehicles are not symmetrical!

•Always wear protective eyewear.

SPEAKER PLACEMENT CONSIDERATIONS

In most cases, your speakers will be placed into factory speaker locations. If you have some speaker mounting flexibility, keep the following in mind:

Lower mounting locations, such as the lower front corner of a door or a kick-panel provide the greatest path length distances for the sound emitted by the speakers. For this reason, they are generally more desirable than higher mounting locations. Higher mounting locations will usually result in extreme near-side soundstage bias which compromises the stereo listening experience.

Due to ongoing product development, all specifications are subject to change without notice.

3