S T E P 1 2
Using a Unibit® or, a 9/16” drill bit, drill out the two holes as marked in the previous step. DO NOT DRILL DEEPER THAN 1/2” or you run the risk of scarring (or penetrating) the outer sheetmetal of the car.
S T E P 1 3
Slide the two Speed Nuts into location with the “Nut” side towards the outside of the vehicle into position over the two holes that were just drilled as shown. Install the two
S T E P 1 4
Hook up the wire from the amplifier to the Stealthobx®and, slide the enclosure into place over the two Allen Head Set Screws installed in STEP 13. Mount the enclosure using the included Fender Washers, Split lock Washers and, Hex Nuts as shown. If neccessary, use a Allen Wrench to keep the Allen Head Set Screws from rotating while tightening. Remember to
S T E P 1 5
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
| ||
I N C L U D E D H A R D W A R E |
|
|
2) | 2) | |
2) 3/8 x 2” Fender Washer | 2) 3/8” Split Lock Washer | |
2) |
|
|
S P E C I F I C A T I O N S |
|
|
|
|
|
Enclosure Type: Acoustic Suspension (sealed) |
|
|
Driver Type: |
|
|
Nominal Impedance: 4Ohms |
|
|
Continuous Power Handling: 500Watts |
|
|
|
|
|
P o w e r R e c o m m e n d a t i o n |
|
|
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1v2 when being used to power your Stealthbox®.
The JL Audio 250/1v2 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.
M I D / H I G H F r e q u e n c y D r i v e r F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors
Fits JL Audio Models:
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door
Fits JL Audio Models:
(954) | www.jlaudio.com |
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
Page 3 • JL Audio, Inc 2009
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
