JL Audio SB-N-FRNTCC/10W1v2/TN Remove the sill plate SB-N-FRNTCC/10W1v2INSTRSKU#011229, E P 1

S T E P 4

Remove the sill plate.

SB-N-FRNTCC/10W1v2_INSTR_SKU#011229

S T E P 8

Lower the seat down onto the Stealthbox®. Line up the top corner of the Stealthbox® to the bottom corner of the seat.

Flip the seat up and push down onto the top of the Stealthbox®.

Unbolt the Z-bracket and remove the Stealthbox® carefully, leaving the wax square in place. The socket cup set screw will leave an impression in the wax.

Using an utility knife, cut an “X” through the wax square at the impression of the socket cup set screw and through the carpet.

6-inches

5-inches

S T E P 5

Place the middle of the wax square into place, shown in the picture.

S T E P 6

Trucks that are equipped with the factory woofer. Use the supplied 6mm bolt to secure the short end of the supplied Z-bracket to the floor, as in the picture. Only hand tighten at this time.

Trucks that are not equipped with the factory woofer. Feel for a mounting point that is located under the carpet and on the floor area that slopes up. Once found, cut the car- pet around this mounting point. Use the supplied 6mm bolt to secure the short end of the supplied Z-bracket to the floor. Only hand tighten at this time.

S T E P 7

Place the Stealthbox® into the mounting location.

Use a supplied 3/8-inch bolt to secure the long end of the Z-bracket to the top of the Stealthbox®. Only hand tighten at this time.

S T E P 1 0

Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case (4x4 vehicles)

or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling!

With a 1/2-inch drill bit and drill, place the drill bit through wax square and the carpeting at the impression made in the wax square. Drill through the metal floor. Remove the wax square.

S T E P 1 1

Place the sill plate back into place.

S T E P 1 2

Place the Stealthbox® into the mounting area.

Run speaker wire to the Stealthbox® and wire to the terminal. Double check the woofer for proper operation.

Back out the socket cup set screw to expose 2-inches

Place the Stealthbox® into position by guiding the socket cup set screw through the drilled hole.

Page 2 • JL Audio, Inc 2006 Continued on Next Page