JobSite Systems Package Contents, A30-X12x Removable AC power cord, Preparing For Installation

PACKAGE CONTENTS

■A30-X12 x 1

■Removable AC power cord x 1

PREPARING FOR

INSTALLATION

Place the A30-X12 on a flat level surface like a table or shelf. It should be placed upright so that its weight rests on the four attached feet. Placing the weight of the amplifier on the rear or front panel may result in damage to the amplifier's connectors and controls.

Figure 1

The A30-X12, like any hi-fi component, will last much longer if it is given adequate ventilation for proper cooling. When installing the A30-X12 in a cabinet, be sure that the rear of the cabinet is open to fresh air to provide proper cooling (see Figure 1). If the cabinet’s design will not accommodate an open rear, install two small “boxer fans” to provide continuous airflow into and out of the cabinet (see Figure 2). Place the A30-X12 so that there is at least 5" of free air space above the chassis. If the amplifier is located on a carpeted surface, place a board under the amplifier's feet. Do not block the ventilation holes on the top and bottom of the A30-X12.

Figure 2

Make sure that there is a minimum of 5” of free air space above the amplifier and 3” on each side for proper ventilation.

Allow a minimum of 2” of depth behind unit to accommodate cables and connectors .

If the cabinet rear is not open to fresh air, install two small “boxer fans” to provide continuous air flow into and out of the cabinet.

4