PRODUCT OVERVIEW |
|
The illustration shows how a | Ceiling bracket serves as a “hole |
typical JobSite | |
mounts into a ceiling. | saver” when drywall has not been |
| applied. Cannot be used when |
| installing into existing ceilings. |
Knockout wire tie allows the wire to be secured to the bracket throughout the new construction process. It knocks out cleanly when the speaker is installed.
Wings instantly snap into the bracket without screws.
Dogs swivel 90°, then clamp the speaker frame to the drywall.
Frames are molded with a slight texture to assure good paint adhesion.
Mounting screws tighten the 
“dogs”, clamping the speaker to
the drywall.
Wings are scored for easy size trimming.
Brackets and wings attach to the ceiling joists with nails or screws.
Figure 1 | ||
perfect for moist environments. | ||
|
2
PACKAGE CONTENTS
■Speakers x 2
■Speaker grilles x 2
■Speaker cutout template / paint mask x 1
PREPARING FOR INSTALLATION
If you are installing the
Determine the best mounting locations based on the room layout. Before cutting any holes, make sure the area behind both speakers is clear for installation. Speakers provide the best coverage, when centered in the room. Line up the speakers with a permanently mounted ceiling fixture such as can lights, or a light fixture.
If you are installing the speakers into a new ceiling follow the above recommendations and install a set of JobSite
Run speaker wire from each location to the amplifier location. Label the speakers wires at the amplifier end, so you know which wire goes to each speaker.
TOOLS REQUIRED
■Stud Locator (for existing construction)
■Drywall saw (for existing construction)
■Pencil (for existing construction)
■Cordless screwdriver with No2 Phillips bit
■Wire stripper
■Wire labels
