10.Attach the frame to the bracket by screwing the frame to the bracket using the supplied screws. NOTE: Do not over tighten the screws, this will distort the frame and the grille will not fit.
11.The screws should pull the frame and bracket together (sandwiching the drywall) so that the frame is flush with the wall surface.
12.Strip 1/4” of insulation from the end of each wire.
13.Tightly twist the end of each wire until no frayed ends remain.
14.Attach the speaker wires to the speaker terminal connectors. Connect the negative output from the amplifier to the black terminal. Connect the positive output from the amplifier to the red terminal.
15.Insert the speaker into the frame and snap it into place. See figure 2.
16.Optional: If you are located in an earthquake zone or want the added security of screwing the speaker baffle to the frame, follow the Important Safety Instructions on page 5.
17.Repeat steps
18.After making tonal adjustments on all speakers
Figure 2
Installation New Construction:
The speaker brackets should be installed prior to the drywall.
1.Attach the wings to the bracket by snapping them into the sides of the bracket. (See Figure 1). To shorten the wings, break them along the scored lines.
2.The wings and brackets have centering lines to simplify placement of the speaker.
3.Use a tape measure to locate and center the brackets in the wall.
4.Mark each speaker location with a pencil.
Figure 3
Break away two of the outer | Emergency |
mounting tabs on the side | screw hole |
you wish to affix. | for butting |
| bracket |
| against |
| joist. |
5.Screw one side of the assembled bracket with wings to the joist using one of the supplied screws.
6.Screw the other side of the bracket/wing assembly to the joist. Two screws on each side make for a very secure installation.
7.Secure the wire to the bracket using the bracket’s wire tie.
3
