John Lewis JLWD 1609 instruction manual Unpacking, Positioning, Installation on a suspended floor

Models: JLWD 1609

1 32
Download 32 pages 18.93 Kb
Page 7
Image 7

Unpacking

All transit bolts and packing must be removed before using the appliance.

Keep all packaging away from children.

You are advised to keep all the transit bolts for re-use in case the machine is to be transported again.

After removing all the packaging, with assistance carefully lay machine on it’s back to remove the polystyrene base from the bottom.

Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance.

HEC0008

HEC0001

With the spanner provided unscrew and remove the central rear bolt A.

Unscrew and remove the two large rear bolts B and the six smaller bolts C.

the corresponding plastic plug caps supplied in the bag containing the instruction booklet.

HEC0010

HEC0005

 

Connect the water inlet hose as described under the paragraph “Water inlet”.

Important !

You are advised to keep all the packaging for re- use in case the machine is to be transported again. In case of moving out the same precautions as per paragraph “The dangers of freezing” must be taken i.e. the residual water in the hoses must be pumped out.

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the

A

HEC00022

 

 

C

 

 

B

HEC0003S

C

B

machine does not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of

Remove the bracket D, refit the six smaller bolts C and slide out the relevant plastic spacer E.

the machine.

D

HEC0011S

E

C

HEC0023 C

Warning

The machine should NOT be placed on deep pile carpeting.

Installation on a suspended floor

Open the porthole and remove the polystyrene block fitted on the door seal.

Fill the smaller upper hole and the two large ones with

Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor

7

Page 7
Image 7
John Lewis JLWD 1609 Unpacking, Positioning, Installation on a suspended floor, Install the machine on a flat hard floor