HOW TO INSTALL
H A R D W A R E |
POCKET DOOR PRIVACY LOCKS
TM
Privacy Pocket Door Lock 1534
For 1-3/4" Thick Doors
Important: Do Not Remove Screws from Locating Blocks on Plate
1. MARK DOOR Mark door fordoor, and 15/16" bore on edge of door approximately | 1534 |
| |
36" above floor. *NOTE: LOCK WILL FIT AND |
|
FUNCTION PROPERLY IN EITHER 15/16" OR 1" |
|
BORE FOR LATCH BOLT. |
|
2.BORE HOLES Bore
3.REMOVE STRIKE Remove strike plate from lock by depressing latch release.
4.INSTALL LOCK Install latch bolt by depressing nylon locking button on bolt to clear 15/16"* hole. Be sure that locking button is on the locking side desired.
A/ Place Plate with locating blocks opposite locking side into
slot, insert “Locking Button Extension” into locking slot. Place locking slot face plate and
“Locking ButtonExtension” over locking button and secure with 1/4" screws provided.
B/ Snap “Latch Button Extensions” onto latch button ends.
C/ Fasten latch plate in mortise with 3/4" screws provided.
5.INSTALL STRIKE Slide pocket door closed, hitting jamb to mark location. Drill 15/16" hole 1" deep in center of marks made by latch. Place strike plate in 15/16" hole, making sure plate is plumb with jamb,
then mark and mortise, 1/8" deep. Secure with 3/4" screws provided.
L.E. JOHNSON PRODUCTS, INC. • 2100 STERLING AVE. • ELKHART, IN 46516 • | IN153PDL |
www.johnsonhardware.com | Rev. 9/05 |