Jonsered GR2026L/CL, GR2032L Assembling other guards and cutting equipment, Assembly, Dismantling

ASSEMBLY

Assembling other guards and cutting equipment

Assembling and dismantling the two-part shaft (GR2026CL)

•Fit the guard (A) intended for use with the trimmer head. Secure using four bolts

(L)and the support plate

(M)as shown in the diagram.

•Fit the disc drive (B) on the output axle.

•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.

•Insert the locking pin

(C)into the hole to lock the axle.

•Screw on the trimmer head (H) in the direction of rotation.

•Dismantling takes place in the reverse order.

A	L	B
		C
M
	H

Assembling:

•Make sure the handle is loose.

• Guide the cut-out on the lower section of the shaft into the coupling‘s locking plate on the upper section of the shaft. The sections are then locked together.

• Tighten the handle.

Dismantling

•Undo the handle (at least three turns).

• Press the handle towards the coupling.

•Carefully twist the lower section out of the lock.

• Hold both parts of the shaft and pull out the lower section from the coupling.

English – 13