Jonsered LT2223 A2 M, F, AE, C D, B

19

SERVICE AND ADJUSTMENTS

• ATTACH FRONT LINK (E) - Work from left side of trac-

tor. Insert rod end of link assembly through front hole

in tractor front suspension bracket (F).

• Insert end of link (E) into hole in front mower bracket

(H) and secure with washer and retainer spring (J).

E

F

H

J

Fig. 20

• Install belt onto electric clutch pulley (M).

A

B

Fig. 18

Fig. 19

• ATTACH REAR LIFT LINKS (C) - Lift rear corner of

mower and position slot in link assembly over pin on

rear mower bracket (D) and secure with washer and

retainer spring.

• ATTACH MOWER SIDE SUSPENSION ARMS (A) TO

CHASSIS - Position hole in arm over pin (B) on outside

of tractor chassis and secure with retainer spring.

• Repeat on opposite side of tractor.

MCDAEFB

Fig. 22

M

Fig. 21

IMPORTANT: CHECK BELT FOR PROPER ROUTING

IN ALL MOWER PULLEY GROOVES.

• Raise attachment lift lever to highest position.

• If necessary, adjust gauge wheels before op er at ing

mower as shown in the Operation section of this manual.

D

C

Contents

Main I. GENERAL OPERATION SAFETY RULES Safe Operation Practices for Ride-On Mowers II. SLOPE OPERATION SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN IV. TOWING V. SERVICE PRODUCT SPECIFICATIONS TABLE OF CONTENTS CUSTOMER RESPONSIBILITIES UNASSEMBLED PARTS Key(s) A Slope Sheet (1) Oil Drain Tube For Future Use ASSEMBLY TO ROLL TRACTOR OFF SKID (See Op er a tion section for location and function of con trols) CHECK TIRE PRESSURE CHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTS Page KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR HOW TO USE YOUR TRACTOR TO SET PARKING BRAKE (See Fig. 4) F B C TO ADJUST MOWER CUTTING HEIGHT (See Fig. 8) REVERSE OPERATION SYSTEM (ROS) A S TO ADJUST GAUGE WHEELS (See Fig. 9) BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL ADD GASOLINE SERVICE REMINDER/HOUR METER PURGE TRANSMISSION TO START ENGINE (See Fig. 3) MOWING TIPS GENERAL RECOMMENDATIONS BEFORE EACH USE T R A C T 0 R E N G I N E TRACTOR BLADE CARE BATTERY BLADE REMOVAL (See Fig. 14) TRANSAXLE MAINTENANCE TRANSAXLE PUMP FLUID V-BELTS TO CHANGE ENGINE OIL (See Fig. 15) LUBRICATION CLEANING AIR FILTER ENGINE COOLING SYSTEM Page M F AE C D B TO LEVEL MOWER TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 27) TO CHECK BRAKE TO REPLACE MOTION DRIVE BELT (See Fig. 28) TO REMOVE WHEEL FOR REPAIRS (See Fig. 29) FRONT WHEEL TOE-IN/CAMBER TO START ENGINE WITH A WEAK BATTERY (See Fig. 30) TO REPLACE HEADLIGHT BULB INTERLOCKS AND RELAYS TRANSMISSION REMOVAL/RE PL ACE MENT TO AD JUST THROTTLE CON TROL CABLE TO AD JUST CHOKE CON TROL TO ADJUST CARBURETOR STORAGE TRACTOR BATTERY FUEL SYSTEM ENGINE OIL TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION