Unfolding the Stroller
•Keep children away from stroller while unfolding.
•Position the stroller with the handle bar closest to you.
•Release the locking latch located on the right side by lifting the lever off of the extended rivet. See Figure 2.
•Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and pull up and back on the handle until both side frame bars snap into their locking positions in the frame.
CAUTION: While unfolding the stroller be careful to keep your fingers from being pinched by moving parts.
•Lock the safety latch on the lower left side of the stroller by pushing the lever down over the extended rivet. See Figure 3.
•Ensure that the stroller is completely opened and the safety latch is secured before ANY use of the stroller.
Figure 2 | Figure 3 |
! | WARNING |
ALWAYS secure the safety latch on the side of the stroller when it is in the unfolded use position. This will prevent collapse of the stroller should the handle trigger locks be accidentally opened.
Installing the Rear Wheels
•Turn stroller upside down, on a clean surface, so that it rests on the handlebar.
•Insert one end of the rear wheel axle through a rear axle hole in the plastic bracket under the
•Push the axle across and into the axle hole on the other side of the stroller. Note, you may need to guide the axle into this hole. Slide washers over each end of the axle. See Figure 4.
•Place one rear wheel over one end of the axle. See Figure 5. NOTE: The brake teeth on the wheel should be facing inward toward the red brake lever AND the arrow shapes on the tire tread should point toward the handlebar.
•Slide an additional washer over the end of the axle.
•Take one snap pin and insert the straight leg into the small hole in the axle. Push it firmly into this hole until the round portion of the other leg snaps completely around the outside of the axle. See Figure 6.
Page 3 | Caboose |
