Front Wheel Locks
The front wheels can be either in swivel mode or locked mode.
• To put the front wheels in their locked
mode, first rotate each wheel set so that the wheels are pointed straight ahead.
• Pull up on the lever to engage the small |
| |
tab on the lever with the slot in the plastic |
| |
frame sleeve. The lever can be either |
| |
facing forward or rearward to lock the |
| |
wheels. See Figure 6. |
| |
• To unlock the wheels and put them into |
| |
swivel mode, push down on the lever to | Figure 6 | |
disengage the tab from the slot. | ||
|
Installing and Operating the Canopy
•To attach the canopy, position the canopy on the stroller with the visor extension forward.
•Line up the male fittings on the canopy with the female fittings near the center of the stroller and push downward until the fittings snap into place. See Figure 7. Pull upward on the canopy sides to be sure both are snapped securely in place.
•To open the canopy, pull forward on the front edge of the canopy while holding the back edge in place. Once the canopy is fully opened, push down on BOTH side hinges to lock it in the open position.
•The canopy and visor can be adjusted into several positions ranging from fully closed to fully extended, or any position in between.
•The visor can be opened (or closed) by pulling (or pushing) it from under the canopy.
•The canopy will ratchet forward or backward to block the sun. Pull forward on the front of the canopy frame tube to rotate it forward. Pull backward on the rear frame tube to rotate it backward. See Figure 8.
•To close the canopy, unlock the side hinges and pull the front edge toward the rear of the stroller until folded. See Figure 9.
•To remove the canopy, press the lock button on the side of each of the male fittings while pulling upward on the canopy frame. See Figure 10.
Page 5 | Caboose Ultralight Instruction Manual |
