Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
pre-set with a lock code of “0000”. You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the MENU button
π†
To SET LOCK CODE
è
To operate (lock icon appears)
Press ZERO to access the lock code
The first digit will be highlighted
è
To select the number
π†
To move to the next digit
Continue to follow these directions for all four numbers
π†
To FINISH
è
To save settings and exit
(your lock code is now set)
Press the EXIT button when finished
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for information
on setting your lock code).
Initial Setup
25
Set Lock Code
INITIALSETUP
>
SETLOCK CODE
FINISH
SELECT BY
OPERATEBY EXIT BY EXIT
LOCKCODE 0000
THISPROGRAMMING EXCEEDS
YOURRATING LIMITS.
PLEASEENTER LOCK CODE BY
10KEY PAD TO UNLOCK IT.
NO.----
AV-27530\AV-27WR25 ENG 25 12/19/03, 1:41:49 PM