Ground wire connection
screw (not supplied)
Ground wire
Peel off the coating or painting of this section and screw to tighten.
This unit requires a large amount of electrical current during loud volume.
Peel off the coating or painting of the metal part of the car connected to the ground wire and screw to tighten.
If the current cannot flow smoothly, it will cause a poor sound quality, power does not turn on, or the sound will be cut off momentarily.
When this happens, check the condition of the ground wire again. If it does not improve, change the location to connect the ground wire.
ENGLISH
When connecting to power (accessory or memory power) other than the battery.
A loud volume may cause the illumination of the car stereo to dim and the fuse may blow. Connect the power cord only to the plus + terminal of the battery.
Do not cut off the fuse; otherwise, it may be
OK
NO
Fuse | The fuse is cut off. |
15A | 15A |
Be sure to connect the "remote input" to the "remote output" of the car stereo or to the ACC line (power) of the car.
When there is no “remote output”, connect to ACC line (power).
When the line output of the car stereo exceeds 2V, switch the INPUT ATT. switch to "ON".
This unit is designed specifically for a DC12V, minus ground vehicle. It cannot be used in a 24V vehicle such as a large truck.
When remote control is not used, the volume of this unit is fixed at the maximum level.
After connection, reconnect the battery negative terminal and make sure stop lamps and others can operate normally.
TROUBLE SHOOTING
For more details, consult JVC
The power is not on. The sound is disrupted.
•Connect the remote input and power correctly.
•Connect the ground wire correctly to the metal part of the car.
No sound from the speaker.
•Connect the line input or speaker input cord correctly.
13